What can I do if the mesh for the last state was not written to the d3plot after restarting from d3dumpxx?
I performed springback analysis using the seamless method, but no converged solution was obtained. Then I wrote a small input deck and restarted the calculation from d3dumpxx. From the message file, the converged solution was obtained, but when I tried to use Taurus to display it, the mesh for the last stage was not written to the d3plot file. Is there a way to avoid this?
https://www.dynasupport.com/faq/metal-forming/what-can-i-do-if-the-mesh-for-the-last-state-was
https://www.dynasupport.com/@@site-logo/LS-DYNA-Support-Logo480x80.png
What can I do if the mesh for the last state was not written to the d3plot after restarting from d3dumpxx?
I performed springback analysis using the seamless method, but no converged solution was obtained. Then I wrote a small input deck and restarted the calculation from d3dumpxx. From the message file, the converged solution was obtained, but when I tried to use Taurus to display it, the mesh for the last stage was not written to the d3plot file. Is there a way to avoid this?
In LSDYNA, the index for the d3plot file is not correct after you restart from the d3dumpxx file
